How do I enable DNS in edge?

How do I configure DNS in edge?

What is the exact configuration for the DNS in the edge?

I found this answer on Digitalocean forum. Just follow these steps: 1) Open terminal and log in to your DigitalOcean droplet: ssh root@IPADDRESSOFYOURDOINSTALLATION. 2) Start the network service on Ubuntu 14.04: sudo service network-manager start. 3) Open the NM (NetworkManager) manager, click on the Edit Connections button and create a new connection. You should now be able to ping other servers in your environment. 4) You can now use the nameservers that are provided by your internet provider. If you are using GoDaddy, please look into their DNS settings in order to define the nameservers that are needed to resolve names.

How do I enable DNS in edge?

I am connected to my phone over Wifi and I want to route all traffic through the edge server.

How do I accomplish this?

According to Cisco documentation: How can I configure the Edge switch for dual-stack IPv4/IPv6? After the edge switch has been upgraded, follow these steps: Step 1 To access the Edge switch configuration interface, perform the following: If you are using a Web interface to access the switch configuration, enter the IP address of the web interface in the host name field. The web interface uses port number 80.

If you are using a console port, enter the console port number in the host name field. The console port number is assigned by default to port 2701.

If you are using a Telnet connection, enter the Telnet port number in the host name field. The Telnet port number is assigned by default to port 23.

Step 2 Access the Configuration > IP Management > Networking > IPv4 > IPv6 section, as shown in Figure 1. Figure 1 : Configuration interface of the IPv4 and IPv6 protocol settings. This interface enables you to configure IPv4 and IPv6 routing settings and protocol state. The following table describes the sections in the table: Section Name Description. IPv4 Settings This section is used to configure IPv4 static and dynamic routing. IPv4 Protocol State Routing IPv4 protocol state routing. IPv6 Settings This section is used to configure IPv6 static and dynamic routing. IPv6 Protocol State Routing IPv6 protocol state routing. Step 3 Configure the following settings, according to your network needs and requirements: Static Routing Setting. Dynamic Routing Setting. Static/Dynamic Routing. Step 4 After you have configured the IPv4 or IPv6 settings, select Apply. Then, use Step 5 to exit the configuration interface.

Step 5 Exit the switch configuration interface.