How to configure reverse proxy in Apache Linux?

I need to configure Apache 2.

2 on my Ubuntu 14.04 server as reverse proxy. There are lots of tutorials how to configure reverse proxy in Apache on Ubuntu but most of them explain how to configure Apache using configuration files for example .htaccess file. I need to use only two lines in .htaccess file:
ProxyRequests Off. ProxyPreserveHost On. Because all the tutorials say that one of above lines is enough for configuration. Is it correct? Is there any drawback in above two lines configuration? You can put all these configuration directives in a .htaccess file and point your domain's DNS records to your Ubuntu machine. This should work. The downside is that the httpd server's main log file will be flooded with lots of requests.

Here are instructions on how to configure a reverse proxy on Ubuntu. Generate your own certificate. Create a CA key and certificate. The latter can be self-signed and you do not need a separate host certificate. In case your Ubuntu machine has a public IP, it is possible to. configure a reverse proxy on your local network instead of an. internet connection. In this case, make sure the web service is reachable over a non-standard port. A common port is 8080, and you can configure Apache to listen to requests at port 8080. To allow connections from a private network, you can edit /etc/hosts and add a line with the. IP address of your local webserver: 168.12 8080 localhost Run the following commands: sudo apt-get update. Sudo apt-get install openjdk-8-jre openjdk-8-demo. Sudo apt-get install apache2. Sudo mkdir /etc/apache2/ssl/certs. Sudo openssl genrsa -out /etc/apache2/ssl/certs/server.pem 2024 sudo chmod 0400 /etc/apache2/ssl/certs/server.pem sudo openssl req -x509 -nodes -days 365 -newkey rsa:2048 -keyout /etc/apache2/ssl/certs/server.

How to enable SSL on Apache2 Ubuntu?

I am trying to enable ssl for our web apps.

We are using Ubuntu-Server 9 and are using apache2 to serve. What steps need to be followed to get ssl working?
Update: After all of the above I was able to set SSL on this server just by changing the port from the default 8080 to 8081. Here's a great step-by-step how-to guide on how to enable SSL. The guide is more appropriate for Ubuntu but I believe it would work on Fedora too. I haven't tried it myself.

How to configure Apache as a reverse proxy for Ubuntu?

I want to reverse proxy apache from 10.

X server for the ubuntu web servers. I am not able to configure it as a proxy server on ubuntu, please tell how to do it

What you should have in mind that most probably in any situation you'll face the next "obvious solution" will work - and if it doesn't then you might have to put more effort into resolving this issue than you think you will have to, because it's something that is so common. What you might have missed in the other solutions is that by putting. ProxyRequests Off. You are effectively just allowing any request. A basic check for this can be done like: iptables -t nat -A PREROUTING -i eth0 -p tcp --dport 80 -j REDIRECT --to-ports 8080. Where the port you redirect is a dynamically assigned one and the -i eth0 -p tcp (not iptables) is used because the default output interface can change when the computer gets up. If this doesn't help, post a logfile of the iptables output after a restart. Another alternative, which doesn't involve forwarding an entire port to another service but rather just a specific URL, could be achieved with apache like this (for example would become which can then listen on port 8080).